
User Manual for Flexineb E3
Intended Use:
A portable equine nebuliser that turns vet-prescribed liquid solutions into a fine mist for inhalation. Medications must always be prescribed by a vet.
Ref: Intended Use
First-Time Use & Safety
Place gently over the nose and mouth with the exit valve open so your horse breathes normally. Once settled, close the valve and begin treatment. Reopen it slightly if your horse gets anxious. The exit valve can be pulled fully open in an emergency to let your horse breathe freely at any time.
Ref: Safety Information
How to Use — Nebuliser
Check valves move freely → fill the cup as directed by your vet → switch on the controller → nebulisation begins within seconds → auto-shutoff after ~35 minutes, or switch off manually.
Ref: Instructions for Use — Flexineb Nebuliser
How to Use — MDI Attachment
Remove controller, cable and cup → attach the supplied adaptor to the aerosol chamber → rotate chamber horizontal → insert MDI and dose as directed.
Ref: Instructions for Use — Flexineb MDI
Controller Basics
3 power levels (default: level 1). Green battery LED drops as it depletes; turns red when charging is needed. Red flashing bottom LED = fault — contact us for support.
Ref: Controller Functions
Key Specs
-
Battery: 7.4V Li-ion, ~6 hrs run time, 4–5 hrs to charge
-
Cup volume: 10ml (expandable to 30ml)
-
Operating range: 5°C–45°C, up to 95% RH
Ref: Technical Information
Cleaning
Cup: distilled water + 1 drop mild dish soap only, never a dishwasher, never sharp tools on the mesh. Mask: warm water + dish soap, disassemble to disinfect. Controller: keep dry — never immerse.
Ref: Maintenance / Cleaning
Warranty
Mask, controller & cable, power supply: 24 months. Battery: 6 months. Cup: not covered (wearing part).
Ref: Warranty
